[NEBULA] IPSec VPN client not working?
In this new beta release came with IPSec VPN support. But i was not able to get it work with Zyxel own IPSec VPN client software. What made me wonder is that where is the place where i enter the phase 1 and 2 settings? I was only able the find them under the Site-to-site VPN section, but i need to have a IPSec Client working and under that section i don't see any option for phase settings.
Hopefully we get some fix/support for this issue quite soon?
Comments
-
Hello @Heikki
Welcome to the community!
Can you check the VPN client application proposal (IKEv1) setting has use 3DES, SHA-1 as like the below screenshot and please enable X-auth,mode config as well.
Also don't forget to create the VPN user at Organization>Cloud auth. in Nebula control center.?
0 -
Hi Chris. Is there a possible you to take a teamviewer session and we could quickly go this through?
-Heikki
0 -
Hi,
Will PM you, please check the inbox message.
/Chris
0 -
Update this post has been handle via eITS channel, for everyone who doesn't know how to configure IPSec VPN client can refer to this Link in FAQ?
0
Categories
- All Categories
- 415 Beta Program
- 2.4K Nebula
- 151 Nebula Ideas
- 98 Nebula Status and Incidents
- 5.7K Security
- 277 USG FLEX H Series
- 277 Security Ideas
- 1.4K Switch
- 74 Switch Ideas
- 1.1K Wireless
- 42 Wireless Ideas
- 6.4K Consumer Product
- 250 Service & License
- 395 News and Release
- 85 Security Advisories
- 29 Education Center
- 10 [Campaign] Zyxel Network Detective
- 3.6K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 75 Security Highlight