XGS1930-52HP 10G port cannot link up
Options
I've bought 2 XGS1930-52HP, while connecting both switches with dac cable on port 49~52, it won't link up. I'm pretty sure that the dac cable is in good condition, because I've tested it on other device. Is there anyone here also encountering the same problem? Thanks in advance.
D,
D,
0
Accepted Solution
-
Hi @D_Shadow,
You will need to access the local web GUI of the switch and change the port media type to "dac10g" mode to be able to link up using dac cable, as figure below:
WEB GUI > Basic Settings > Port Setup
Hope it helps.
Jonas,Jonas,0
All Replies
-
Hi @D_Shadow,
You will need to access the local web GUI of the switch and change the port media type to "dac10g" mode to be able to link up using dac cable, as figure below:
WEB GUI > Basic Settings > Port Setup
Hope it helps.
Jonas,Jonas,0 -
Hi Jonas,
At last, the link is up now.
Thanks for the answer.
Just wondering, why it cannot be configure on Nebula?
D,0 -
Hi @D_Shadow,
Thanks for the suggestion.
I would like inform that, it was already included on our roadmap.
Please stay tuned.
Jonas,0
Categories
- All Categories
- 384 Beta Program
- 2.1K Nebula
- 117 Nebula Ideas
- 80 Nebula Status and Incidents
- 5.1K Security
- 79 USG FLEX H Series
- 247 Security Ideas
- 1.3K Switch
- 69 Switch Ideas
- 909 WirelessLAN
- 34 WLAN Ideas
- 5.9K Consumer Product
- 209 Service & License
- 335 News and Release
- 71 Security Advisories
- 21 Education Center
- 5 [Campaign] Zyxel Network Detective
- 1.9K FAQ
- 898 Nebula FAQ
- 415 Security FAQ
- 234 Switch FAQ
- 205 WirelessLAN FAQ
- 46 Consumer Product FAQ
- 137 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 73 About Community
- 62 Security Highlight