[092601]automatic Firmware update
Comments
-
I just can say that it was working fine for me directly.
Got notification and upgrade went succesfull.
No manual restart needed.
Due to hat I was not at home when I start it, I couldn't tell you the LED state.
0 -
Red Blinking means FW upgrade error.Maybe your Multy X does not finish download the firmware because Zyxel FTP server too busy or something else. However, when download/upgrade firmware failed, Multy X will boot with original firmware. You can try it later.0
-
@Zyxel_Support
The LED of the multy was blinking more than 8 hours red, so the device never makes a restart on the old firmware.
I understand the mechanism behind it but in my case it never makes a reboot on the latest running firmware.....0 -
We will find out the solution about this situation.1
Categories
- All Categories
- 439 Beta Program
- 2.8K Nebula
- 195 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 475 USG FLEX H Series
- 312 Security Ideas
- 1.6K Switch
- 82 Switch Ideas
- 1.3K Wireless
- 45 Wireless Ideas
- 6.8K Consumer Product
- 282 Service & License
- 446 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight