[NEBULA] Allowed Remote IP
TCL_Support
Posts: 8
Freshman Member
Freshman Member
I am trying to find a good manual that documents everything on the NGG100 gateway but so far have only found the user guide that is good for a general user but not at a network engineering level.
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
Currently I am trying to find out what I can put in the 'Allowed Remote IP' field under the NAT/Virtual Server rules. A single IP address in their works fine but we need to allow a range of addresses to access an open port, i.e. can we put in 51.140.0.0 to use a range of addresses or does it understand 51.140.0.0./14, etc.?
0
Comments
-
Hi @TCL_Support
Welcome to Nebula Forum!
Yes, 51.140.0.0/14 can be understood! The format of Allowed Remote IP field can be as below; you can select one format to apply.
1. A specific ipv4 address, such as 51.140.0.0
2. A valid IP range, such as 51.140.0.0/14
3. Any: to allow any remote IP
0 -
Ok, perfect - at last a feature that works! Many thanks for the answer.
1
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
