Can't set admin password on NAS542
Options
Kris
Posts: 2 
Freshman Member
Freshman Member
After HW reset.
1: I'm prompt with login request.
2: I use default admin password and is then asked to make new password.
3: I'm back to login page. But my new password i rejected. I can use default password. Then back to 2
I found this question in an earlier thread, but I couldn't find an usable answer.
Any ideas how to proceed?
#NAS_May_2019
1: I'm prompt with login request.
2: I use default admin password and is then asked to make new password.
3: I'm back to login page. But my new password i rejected. I can use default password. Then back to 2
I found this question in an earlier thread, but I couldn't find an usable answer.
Any ideas how to proceed?
#NAS_May_2019
1
All Replies
-
I remember vaguely that I have read about this. Someone had a problem with passwords in the webinterface, and after debugging the webinterface he found that his virusscanner/firewall was responsible for intercepting his actions.
0 -
I have the same problem. Full reset helped.0
Guru Member
Categories
- All Categories
- 439 Beta Program
- 2.7K Nebula
- 191 Nebula Ideas
- 121 Nebula Status and Incidents
- 6.2K Security
- 467 USG FLEX H Series
- 308 Security Ideas
- 1.6K Switch
- 82 Switch Ideas
- 1.3K Wireless
- 44 Wireless Ideas
- 6.8K Consumer Product
- 281 Service & License
- 440 News and Release
- 88 Security Advisories
- 31 Education Center
- 10 [Campaign] Zyxel Network Detective
- 4.3K FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 85 About Community
- 93 Security Highlight
