(EMG3525-q10a) Why are none of my ports open when i port forward

YarBoi · June 2019

I have a EMG3525-q10a router and im trying to set up a forge minecraft server for some friends. I havent been able to port forward since i switched internet providers. I have followed all the steps to port forward. It says my port forward works and is on, but when i use a port tester tool it doesnt work still. All my fire walls are diabled btw

#SP_Jun_2019

Mijzelf · June 2019

I havent been able to port forward since i switched internet providers.

So it worked before you switched? I guess there is another NAT layer now. Did they send a new modem? If yes, check if it's not a modem/router combo. If it is, you'll have to port forward in that router too, or put it in bridge mode. If they didn't send a new modem, it's possible that you are behind a Carrier grade NAT. In that case you'll have to contact your provider how to port forward.

It's easy to find out if there is another NAT layer. Just check if the IP address shown by https://www.whatismyip.com/ is the same as the WAN address of your EMG3525-q10a, as shown in the webinterface.

YarBoi · June 2019

Thank you for helping me. However my internet provider is forcing me to pay to put the modem in bridge mode so I gave up.

Mijzelf · June 2019

If the modem/router supports DMZ, you can put your own router in it. In that case all ports from the modem/router are automatically forwarded to your own router.

(EMG3525-q10a) Why are none of my ports open when i port forward

Accepted Solution

All Replies

Categories

Consumer Product Help Center