NAS326 installing
Kauko
Posts: 2 
Freshman Member
Freshman Member
Hey.
I have a NAS326 which I installed but did not wish it to, then suddenly the router did not find NAS326.
The HD lights are blinking but the IP address is not visible on the router so I cannot access the NAS326 menu.
I reset the router but did not help.
Any ideas for what to do?
Regards Kauko
#NAS_Feb_2020
0
Accepted Solution
-
When NAS326 is connected to the router, does LAN LED (NAS326 and the router) light?
Do you hear any beep on NAS326?
Here is Rescue Sticks, please find it.
https://homeforum.zyxel.com/discussion/comment/8012#Comment_8012
0
Ally MemberAll Replies
-
Hey.The problem went away!I found the RESET button on the back of the NAS326 which I pressed for about 5 seconds, after a while the device was factory set, after which the router found the IP address !.The quick guide that came with the device did not mention the reset button.Perhaps it would have been mentioned in the more extensive use manual if I had "smarted" to search the web.Thank you for the link you provided.
Best Regards Kauko1
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ