No signal detected on node 2 during “Location check” - what to do?
TCordth
Posts: 3 
Freshman Member
Freshman Member
I have installed node 1 of a Zyxel Multy U succesfully. When I add node 2 i get the following issue. I get all the way to the step where node 1 and 2 are synced, but when i get to the “Check location” step it never detects a signal and i am not able to finish the installation. I have tried with factory reset but I always get stucked in
this step. I have also tried to move the two nodes close to each other without any luck. Have any of you experienced this problem and what is the solution?
#MultyU_Feb_2020
this step. I have also tried to move the two nodes close to each other without any luck. Have any of you experienced this problem and what is the solution?
#MultyU_Feb_2020
0
Accepted Solution
-
Have you tried to switch the primary Multy and second Multy?
You can install the second Multy as the Primary Multy, then add the other Multy.
1
All Replies
-
The switch solved the problem, thanks!!!0
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ