My WRE2205 v1 will not reset
Mike0988
Posts: 1
I updated to the most current verion of firmware and now my unit doesn't work. The Signal light does not illuminate at all and I cannot reset the unit. The Power and WiFi lights are on constant (no blinking). When I connect via Ethernet cable the LAN light blinks, but I am not able to bring up the configuration for the unit.
#WRE_Jul_2020
#WRE_Jul_2020
0
All Replies
-
Have you press the reset button for over 10 seconds, and the power light will blink.
Then the IP of WRE will back to default, and that will be 192.168.1.2
You will have to set your PC to the same IP subnet, such as 192.168.1.100/255.255.255.0
Next, access to the webGUI by typing 192.168.1.2 on the browser.
0 -
Ok, that is clear now. Thank you for your answer.
0
Ally Member
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ