GS1920 missing functionality like link aggregation

Mitsch · June 2021

I've got two GS1920 (one -24 and one -48) in my network. Both are connected to the nebula cloud.
Now I want to use options like link aggregation. It seems that nebula doesn't support these options.
But also the web gui offers my only a "VLAN" submenu if I choose "Advanced Application" in the web gui. That is the only sub menu.

Where can I activate and configure link aggregation?

Zyxel_Jonas · June 2021

Hi @Mitsch,

Just would like to inform that after a device registered on Nebula, all configuration settings needs to be control on Nebula portal.
After logging in, you may go to Switch > Configure > Switch ports, and then choose the switch ports of the switch that you would like to aggregate.
As figure below;

Image: https://us.v-cdn.net/6029482/uploads/editor/po/ser6egxbffea.jpg

Click on "OK" button, to apply & save the configuration.

Image: https://us.v-cdn.net/6029482/uploads/editor/ei/o7h5rjhv21yz.jpg

Tips on how to disable the link aggregation:

Image: https://us.v-cdn.net/6029482/uploads/editor/my/k9dr4eskif3c.jpg

Reminder: After clicking on "Split" button, the link aggregation will be disabled immediately.

Hope it helps,
Jonas

Zyxel_Jonas · June 2021

Hi @Mitsch,

Just would like to inform that after a device registered on Nebula, all configuration settings needs to be control on Nebula portal.
After logging in, you may go to Switch > Configure > Switch ports, and then choose the switch ports of the switch that you would like to aggregate.
As figure below;

Click on "OK" button, to apply & save the configuration.

Tips on how to disable the link aggregation:

Reminder: After clicking on "Split" button, the link aggregation will be disabled immediately.

Hope it helps,
Jonas

GS1920 missing functionality like link aggregation

Accepted Solution

All Replies

Categories

Nebula Tips & Tricks

Nebula Help Center