[NEBULA] Site-to-Site VPN. Two NSG50 connected and tunnel established but now what?
I have two NSG50 units for a headquarters and branch1. I've established a site-to-site vpn using Nebula. Able to ping headquarters Gateway, AP, and printers on site. Able to access web-interfaces for printers. Was not able to ping target PC at headquarters. Not able to see shared network resources under Network on branch1 PC. What step(s) am I missing in Windows to make this work? Creating security policies and generating certificates?
0
Comments
-
Have you disable the firewall rule on windows? Maybe that's why there is no respond.
As I recall, you cannot find the shared folder in the network neighborhood, since their VPN tunnel doesn't allow broadcast traffic pass through the tunnel.
You can try to access via IP directly.2 -
If I disable the private network firewall I can ping each target PC, map network drives and printers by their IP address. Resolved!
0 -
Freshman Member
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
