Nebula and CLI

Hi everyone,

I would like to capture packets on CLI of a Nebula connected security appliance.

But when requesting the interface status, I do not get the configuration as shown in Nebula.

For example, here is how the USG Flex is configured in Nebula :

• wan1 : PPPoE (fixed public IP from ISP)
• lan1 : 192.168.10.0/24
• lan2 : disabled

Using a SSH connection to this router, I type this command :

show interface all

And the answer is :



Nothing to do with the Nebula configuration.

What I need is troubleshooting an RDP remote connection on port 3389. I would like to see if the packets are well received by my WAN interface like this :

packet-trace interface wan port 3389

0 packets are captured event if the connection is successfull !



I have the same problem with ddns, nat rules, secure-policy rules, ... The CLI do not return the Nebula configuration but the default rules as if the apppliance would be in stand-alone mode.

What am I doing wrong ? Wrong command ? Wrong command context ?

Regards,

Sebastien