How to configure Vlan Trunk - Gs1910
KleinStreisend
Posts: 6
Good afternoon, could you tell me how to configure the trunk port for vlan on the zyxel gs1910 switch. I have 2 vlans 100 and 200.
It is necessary to connect 2 switches so that vlan traffic passes between them.
Also, these ports are aggregated via LACP. Actually, I need to make them a trunk port.
Also, these ports are aggregated via LACP. Actually, I need to make them a trunk port.
On cisco, this is done through the "switchport mode trunk" command.
0
Accepted Solution
-
Hi @KleinStreisend,
Welcome to Zyxel community!
Looks like you want lacp ports could transmit VLAN 100 & 200, right?
If yes, you just need to set "1,100,200" in Allowed VLANs on lacp ports.
Hope it Helps.
Melen1
Zyxel EmployeeAll Replies
-
@Zyxel_Melen
thank you very much, yes it is working perfectly.
On the cisco side work with -
switchport mode trunk
switchport nonegotiate0
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
