XS1930-10 as a L3 WAN Router?
The XS1930-10 seems to have the full capabilities of a L2 and L3 router, it even has a DHCP relay. However, I cannot figure out how to configure a port as NAT and route accordingly. Is there a basic guide to setting this up properly for one port to act as an IPV4 NAT to a specific VLAN ?
0
All Replies
-
NAT is done by a router a switch can't NAT many MAC's for a LAN to go out a given WAN IP by a given MAC.
If you make your client have the same MAC (and ideally the same the DHCP requests) you can (works on my GS2210) use VLAN to make the switch like a hub and not conflict their being the same MAC this does mean the clients are isolated.
0 -
Guru Member
Zyxel Employee
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
