NAS540 Still Repairing after 72 hours
Causingfire
Posts: 3
I had a drive fail on raid 5 configuration. I replaced the failed drive and started the repair process. After the resync progress it is now at "repairing" for 15 hours.
Looking at dmesg and mdadm --detail; it looks like it finished.
Is there any other step to complete the process or did it finish and the UI is bugged out?
0
Accepted Solution
-
Have a look with top if e2fsck (filesystem check) is running. If not, and nothing important is active, just assume the webinterface is buggy.
0
Guru MemberAll Replies
-
I think the gui reads the content of /proc/mdstat to show the status.
0 -
/proc/mdstat doesn't show a recovery status, and the UI is still showing repairing...Is anything else I should check?
0 -
Thanks, I restarted the NAS and now it is showing healthy again
0
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 908 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
Consumer Product Help Center
FAQ