freeze NAS542

All Replies

• 

  fffas Posts: 9  Freshman Member

  

  October 2022

  As your slot 1 kernel boots, and your slot 2 doesn't, it could help to auto boot the other kernel.

  how to do it , in detail please ?
  

  0
• 

  Mijzelf Posts: 2,989  Guru Member

  

  October 2022

  By exchanging the values of next_bootfrom and curr_bootfrom. The default startscript reads curr_bootfrom to decide which kernel to boot.
  

  0
• 

  fffas Posts: 9  Freshman Member

  

  October 2022

  I did it .And the firmware from the recovery flash drive went.Attached is the log from the recovery flash drive." /env/config" has changed and now the start ends -
  
  Hit any key to stop autoboot:  1booting kernel of type uimage from /dev/nand0.kernel1.bbBad Header Checksum Failed.booting kernel of type uimage from /dev/nand0.kernel2.bbBad Header Checksumwarning: No MAC address set. Using random address 1E:9B:53:E9:9E:FFT T T T

  flash 2.zip 2K

  0
• 

  fffas Posts: 9  Freshman Member

  

  October 2022 edited October 2022

  I killed six hours today trying to connect to the board via ethernet ... no, no way ...

  So I'll look at the board. Bingo ! Torn off quartz resonator on the zero port of the ethernet !!! The dude who sold me the NAS apparently used a different port.

  
  

  there is good news

  1. finally everything works electrically.

  2 set up, learned and was able to connect via TFTP server)))

  
  

  Tomorrow I will try to raise the firmware ...

  0