ZYXEL USG FLEX 100W Log Display Options
Freshman MemberI don't know when this changed but when looking at my logs, they used to contain IP addresses. When the log is emailed to me, the IP address are there.
What setting or filter would stop me from seeing IP address information while looking at my log?
Hope this makes sense
0
Accepted Solution
-
0
Zyxel Employee
All Replies
-
Not that much.
There were IP addresses in your emailed log and now there are no more?
There were not IP addresses in your emailed log and now there are?
Pick one of the two...0 -
Here is my question again,I don't know when this changed but when looking at my logs (From the Flex 100), they used to contain IP addresses. When the log is emailed to me, the IP address are there.So what I'm trying to say is that when I'm viewing the log, while logged into the FW the logs do NOT show IPs anymore. The only way I see the email address is after the log is sent to my email.Sorry if it was not clear....it was still early
I didn't see anything in the filter that would prevent me from seeing the IP, it's just odd that they are there after it is emailed.Thanks!
0 -
I did have those checked.....turns out I just had to shrink my page view and spread out the collums. It was there, it was just not visible due to my view settings!Thanks! I should have caught that myself!0
Guru Member
Categories
- All Categories
- 164 Beta Program
- 1.7K Nebula
- 86 Nebula Ideas
- 62 Nebula Status and Incidents
- 4.7K Security
- 236 Security Ideas
- 1.1K Switch
- 50 Switch Ideas
- 907 WirelessLAN
- 27 WLAN Ideas
- 5.3K Consumer Product
- 172 Service & License
- 294 News and Release
- 65 Security Advisories
- 14 Education Center
- 911 FAQ
- 399 Nebula FAQ
- 249 Security FAQ
- 90 Switch FAQ
- 100 WirelessLAN FAQ
- 18 Consumer Product FAQ
- 55 Service & License FAQ
- 34 Documents
- 34 Nebula Monthly Express
- 68 About Community
- 51 Security Highlight
