USG FLEX 200.Access to Web interface troughth WAN2(P2)

Options
bk1
bk1 Posts: 5 image  Freshman Member
First Comment Friend Collector
in Security
Hello. I have USG Flex 200 with firmware V5.32(ABUI.0). 

WAN1(P2) -  main provider. 
WAN2(P3) -  reserved provider.

I can't get access to Web interface when I try connected via WAN2(P3) but via WAN1(P2) - OK.
I changed settings on WAN2(P3) and connected my main provider, disable firewall, but i still can't connected.
What am I doing wrong?

Accepted Solution

  • bk1
    bk1 Posts: 5 image  Freshman Member
    First Comment Friend Collector
    Answer ✓
    @PeterUK Yes, I did it (Nat 443), doesn't work.
    Today I Captured traffic for interface WAN1 and WAN2. Then I understood that problem with routing and created policy route. It helped for me. 

All Replies

  • PeterUK
    PeterUK Posts: 4,411 image  Guru Member
    250 Answers 2500 Comments Friend Collector Eighth Anniversary
    edited November 2022

    Might it be that you have made a NAT rule for port 443 on P3 to a LAN device? or even NAT 1:1?

    or could your reserved provider not allow port 443 inbound or any inbound connection?


  • bk1
    bk1 Posts: 5 image  Freshman Member
    First Comment Friend Collector
    Answer ✓
    @PeterUK Yes, I did it (Nat 443), doesn't work.
    Today I Captured traffic for interface WAN1 and WAN2. Then I understood that problem with routing and created policy route. It helped for me. 

Categories

Security Help Center

EnglishTiếng ViệtРусскийไทย中文（台灣）