USG Flex 200 - Firewall by WAN

2»

All Replies

  • PeterUK
    PeterUK Posts: 2,195
    100 Answers 1000 Comments Friend Collector Fifth Anniversary
     Guru Member
    edited January 12

    I'm not sure what Zyxel was thinking with a cut down feature for Nebula, I want the kitchen sink. ;)


  • Zyxel_Jeff
    Zyxel_Jeff Posts: 826
    50 Answers 500 Comments Friend Collector Second Anniversary
     Zyxel Employee
    WAN1: Allow HTTP-HTTPS-POP3-SMTP
    WAN2: Allow POP3-SMTP

    Now if i configure a policy routing for POP3 and SMTP they pretend to work only on WAN1 or only on WAN2 but cannot work on both of them, also i have WAN2 that is a backup channel with low limit on monthly bandwidth so i cannot pretend to use it when WAN1 is working and cause to break the monthly limit costantly.

    aalfano_sirm


    Regarding this requirement,  maybe you could consider deploying the USG Flex 200 to on-premise mode and configuring two security policies to meet your requirement, as in the below example:

    WAN1_Policy to allow HTTP-HTTPS-POP3-SMTP services.


    WAN2_Policy to allow POP3-SMTP services.


    Thanks.
  • Pook
    Pook Posts: 130
    First Answer First Comment Friend Collector Nebula Gratitude
     Ally Member
    I want to try and help, so essentially you just want SMTP traffic (Port 25) to send out via WAN2?

Categories

Nebula Tips & Tricks


    Read more

    Nebula Help Center

  • FAQ
  • New & Release
  • Nebula Status & Incidents
  • Video Tutorials
    • EnglishTiếng ViệtРусскийไทย中文（台灣）