USG 110 : Traffic WAN statistics

kyssling
kyssling Posts: 102  Ally Member
First Anniversary 10 Comments Friend Collector First Answer
edited April 2021 in Security

Hi, please can somebody explain me our statistics ? We have both WAN active on our LAN. VPN from outside going to WAN2 connection. On statistics is WAN2 traffic almost zero.

I have the feeling that internal traffic to internet goes all over WAN1, BUT WAN configuration i set BOTH Active.

Thanks for help.


All Replies

  • jasailafan
    jasailafan Posts: 189  Master Member
    First Anniversary 10 Comments Friend Collector First Answer

    Hi kyssling,

    This KB may be helpful.

    If WRR is configured with WAN 1 weight 3 and WAN 2 weight 1, will there be 3 times of traffic loading coming in from WAN 1 compared to WAN 2?

    https://kb.zyxel.com/KB/searchArticle!gwsViewDetail.action?articleOid=015862&lang=EN

  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,426  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    @jasailafan , Thanks for information providing.😀


    Hi @kyssling

    Obviously, most traffic goes to wan 1 interface. 

    Do you have any policy route “next-hop” set to wan1 interface?


    Go to “CONFIGURATION > Network > Routing > Policy Route”


  • kyssling
    kyssling Posts: 102  Ally Member
    First Anniversary 10 Comments Friend Collector First Answer
    edited August 2019

    Very thanks for response we have only this settings on policy route:


  • Zyxel_Cooldia
    Zyxel_Cooldia Posts: 1,426  Zyxel Employee
    First Anniversary 10 Comments Friend Collector First Answer

    Hi @kyssling

    Can you send me your configuration file via private message.

  • kyssling
    kyssling Posts: 102  Ally Member
    First Anniversary 10 Comments Friend Collector First Answer

    If someone solves a similar problem, just switch to Traffic-Statistics - Sort by: Service / Port (no default Host IP Address / user) ...

    where we can see MultiWan statistics better ...

Security Highlight