Miaa  Freshman Member

Hi gabor2, I use two laptop connect to LTE3301-PLUS WiFi 5GHz SSID, ping from router to host and get the different result, it seems ping response time depends on the host. ping router->laptop 1 ping router->laptop 2

Hi bhliedtke , did you connect device GUI 192.168.1.1? What is router firmware version on LTE3316 and what error occur on browser when you connect 192.168.1.1?

Hi Tamir, you can connect a PC to NR7101 LAN(such as NR7101[LAN]<-->PC) and PC check "ifconfig" for the default gateway to access NR7101 GUI to configure it.

Hi bhliedtke , did you connect device GUI 192.168.1.1? What is router firmware version on LTE3316 and what error occur on browser when you connect 192.168.1.1?

Hi Tamir, you can connect a PC on NR7101's LAN via Ethernet cable(such as NR7101[LAN]<-->PC), and PC perform "ifconfig" on Command Prompt to check default gateway. Then you can access NR7101 GUI with default gateway to configure it.

It looks good.

Hi pacala, you can enable IP Passthrough feature on LTE3301-PLUS GUI page(Network Setting>Broadband>Cellular IP Passthrough). For public IP, you may need a special APN, username and password from you Internet provider, and configure these information on Cellular WAN GUI page(Network Setting>Broadband>Cellular WAN>APN…

Hi pacala, you can enable IP Passthrough feature on LTE3301-PLUS GUI page(Network Setting>Broadband>Cellular IP Passthrough). For public IP, you may need a special APN, username and password from you provider, and configure these information on Cellular WAN GUI page(Network Setting>Broadband>Cellular WAN>APN Settings). I…

Hi jamiedgwilson, you can try Connection Control as Auto Reconnect(always-on) if you don't want the connection to time out. Also, enable the Network Monitoring that LTE3301 test connection periodically sending DNS Query to DNS server or ICMP Checking sending the ping to the address you specify in Target1 and Target2…

Hi Gimpymoo, you can enable Ethernet WAN that convert the LAN port 4 to Ethernet WAN (Access GUI>Network Setting>Broadband>Ethernet WAN>State: Enable). And then configure Wireless settings as you want.

Hi Charly, from your picture, assume LTE3301-PLUS just connect mobile network to access Internet for purpose, so no need to do anything on it and LANX is same IP range as LAN1. If you want LAN1 access to LAN2, you need configure on DDWRT that create rules(such as port forwarding) on DDWRT to allow LAN1 access LAN2 specific…

Assume the Connection Control set as Connect-on-Demand and the default max idle time is 600 seconds , the connection will time out in the max idle time. Reverse , set as Auto-Reconnect the connection keep always on. You can check configuration on Management WAN page. (Go to GUI>Configuration>Network>WAN>Management…

You can check the sim card(nano sim with card adapter) if accurate insert to the card slot of LTE device, and noticed if LTE device have reboot before the problem happen.