Comments
-
Hi everyone, could you confirm whether today's forced update will cause any of the Firewalls to reboot automatically? Just we have quite a few in live / working environments using VPN's....All the best - Adam
-
If you have a Flex or ATP firewall is this necessary?
-
I think the USG Flex Supports this?
-
I have another Flex 700 arriving today to go on another site that has a 1Gbps connection. I will run some speed tests and update the results here.
-
Thanks Charlie, where can I disable Traffic statistics and what is BWM?
-
Should anyone else need to know it works fine just leaving the USG Flex in DHCP mode for the WAN.
-
Thanks Melen, I have a Flex 100 to set up next week and I will test :-)
-
I would like to suggest displaying the LED status in the web interface or Nebula NCC. It would save having to ask someone to physically check on a remote site.
-
So I had to plug into another DHCP device to WAN1 that was different to the IP scope on WAN2. Then after removing I could add and save PPPOE details.
-
Whats the PIN out plan for the devices? Is it all the same?
-
This is a valid point, now the NSG50 is EOL the only entry level Nebula gateway is the Flex100. ZyXel need to release a Nebula USG-Flex50 to fill the gap.
-
How about a ICS outlook file for Nebula License reminders?
-
Allow ZTP fuction to specify desired port for WAN setup. For example I deploy to our workshop LAN on DHCP so WAN2 (P1 On Flex100) so we can run updates and soak test. Then when ready I can configure WAN1 for the deployment site.
-
Please make it Possible to change WAN interface names On USG-Flex firewalls. Drives me crazy lol
-
You can add the switch to your Nebula but it will consume some of your Pro points and it will reduce the co-termination time.