jeffjohn1941  Ally Member

sorry from 192.168.0.xx to 141.98.10.62

Does this imply to USG110 also? (

Huaweii 3531 VOIP de-registers. Instant recovery when LTE Dongle removed. Dongle works fine otherwise.

sorry - I just inserted a quick rough translation for Stephane76!

I configure my USG60 in bridge so as not to have to change the configuration of the existing network, so I created a bridge with my LAN1 and WAN2 with a local network address (192.168.1.100) and the gateway address ( ISP router 192.168.1.254). I go out on the internet no problem. I have to put a backup link via a 4G router…

My sincere apologies! Apparently I had not saved my bridge settings; I repeated all steps and this time all worked! So sorry to waste your time, Jeff

Hi- thanks for your interest. Router is SBG3300. I tried disabling firewall but same result. The Config - licensing-registration "portal.myzyxel.com" tries to link to 192.169.1.43/myzyxel_registration.cgi where local IP is the device. I did try different default browsers. ( p.s. I shall be transferring the USG to another…

thanks for replies. I see that as my USG110 is behind a router in bridge mode, the link fails, trying to connect to an internal local address. Myzyxel reg etc works via web browsers ok, but auto f/w updates and signatures do not function. (No great problem).

Zyman! Thank you so much for your very detailed explanations. Absolutely perfect for my needs. I shall set up the USG here (UK) before my next visit to France later and will implement your suggestions. I'm sure all will be well! I'm very appreciative of your detailed guidance. Regards jeff

Hi Zyman! Thank you for your interest in setting up my USG110. As I said, I have used a Zywall 5 successfully for 5 years or more, simply set in 'bridge' mode. The device is managed both locally (LAN) and from UK using site-to-site Ipsec connection and local IP address. I have been given an unused USG110 and keen to…

My translation: I have a speed restriction on my USG60, I'm on the fibre, and my ISP has recently increased the symmetrical speed of 300Mbit to 1Gbit. If I connect my pc live to the "fibre router", I actually have 1Gbit,but after the USG60 which is plugged into the "fibre router", my speed never exceeds 300Mbit in both…

I think I was mislead by the online speed test (btwholesale). I tried with www.thinkbroadband.com and attained about 52Mb/s and downloaded a 1GB file at 55.2 Mb/s so no problems at all. Thanks for your suggestion, though.

MS quote: In Windows 8, 8.1 and Windows 10, the default shutdown behavior puts the system into the hybrid shutdown state (S4), and all devices are put into D3. WOL from S4 or S5 is unsupported. Network adapters are explicitly not armed for WOL in either S5 or S4 cases because users expect zero power consumption and battery…

MS state: In Windows 8, 8.1 and Windows 10, the default shutdown behavior puts the system into the hybrid shutdown state (S4), and all devices are put into D3. WOL from S4 or S5 is unsupported. Network adapters are explicitly not armed for WOL in either S5 or S4 cases because users expect zero power consumption and battery…

Many sincere thanks for your assistance. I am embarrassed, however, to say that I now understand my problem was due to Win 10 Pro not supporting Wake from the PC power-OFF. After leaving in S3, (sleep) state no problems with Wake.