Comments
-
Status: Now running 3 days, 14 hours and memory usage is at 95% again. @Zyxel_Bella This support option isn't available as these units are not connected to Nebula. We'll try to rebuild the config from factory default again, before reverting to the old firmware.
-
A few days later I'm reconsidering this version; after just two days memory use has increased again from 43% to 70% and rising. This morning, 24 hours after another reboot, it has risen again from 43% to 62%. This quick rise was not the case with earlier version 6.20 before the Frag-hotfix. When memory use rises above 85%…
-
Maybe the memory overflow bug in the previous version?
-
Same here with 6.25 on our WAX650S unit. After installation, soft reboot (and DCS) most connections would fail, especially on all 5GHz channels. Only a power cycle seemed to help, but again DCS caused problems on channels above 56, even though all clients could connect fine before. After a second powercycle the AP worked…