Comments
-
I will zip it up again. I could not load a "TAR" file generated from USG.
-
Never mind, it finally finished, took about 8 or more minutes. Will post in PM. -Bob
-
Joslyn, How long does it take to collect? I see the message below, been posted for over 5 minutes... Please wait, collecting... Just wondering if this takes a while (does it wait until Log fills?). -Bob
-
Hi @Zyxel_Joslyn I looked at logs and nothing about WiFi. In Monitor Section no SSID is displayed see image.
-
Hi @Zyxel_Joslyn I had a similar problem in 4.35. I don't think it happened 4.38. Once WiFi Radio is offline it doesn't come back without reboot. I use inSSIDer to monitor WiFi (CH6) and it just isn't there (no SSID or signal). I emailed log to myself, will copy & PM. I haven't rebooted yet (I want to rely on this WiFi for…
-
{destination Address xxx.xxx.xxx.xxx:1028 "ACCESS BLOCK"} The destination Address was the WAN Public IP. Forgot to mention this......
-
I wanted to report I tested WiFi Camera with a USG60W 2.4GHz radio set for strictly AES, and it worked (stayed connect for a week), I had to shipped back USG60W when Tech Support told me WAN cannot run at gigabit speed. I updated my USG20W-VPN firmware to 4.38 (same as USG60W) and Camera still will not connect, or see WiFi…
-
Thanks mMontana! Answers below: Which channel is using USG? WiFi nation/region is the correct one for your country? USG Set to CH6 US (Other access points on CH11 & CH1). Wifi country is the right one on the WiFi Camera? YES (Sold in US, and Works ON OTHER US WAPs set for AES) I would not use TKIP for any of my wireless…
-
Stanley, Thanks for clarifying. I must have seen them when the 30 day trial Content Filter was active. That would explain why I saw them on older firmware, because I viewed logs after performing my initial configuration, getting a feel for the router. Thanks for clarifying!