Peter2 
Master Member
-
Re: DX3301-T0 Telnet
Telnet is activated by default (only via local Lan) but you cannot configure it in the menu section, you can try this and check out if you make a fault using your SSH client . But i revieved this and…1 -
Re: Isolate server from home devices on AX7501-B
If the separation with interface grouping is not enough for you and and Vlan only works if the devices are configured for Vlan too you can you use a managed switch that separates Vlan segments for yo…1 -
Re: VMG devices bridge mode not accessible via it's management IP
Of course this is your decision … One thing at last - may be its better to give the new interface on Lan4 really a adress in your primary lan like 192.168.1.252 and the modem adress change to 192.168…1 -
Re: 4g support list for Zyxel ex5601-T0
Yes the current WWAN package is 1.24 you can check it in the firmware menu . I tested a 3372 with zycel device and it worked fine , you have to configurate it in the wan menu compare the requested va…1 -
Re: HTTPS connection from EX3301-T0 to NAS drive WAN to LAN
I think you should setup the dynamic DNS with the Router itself in the DNS section , you see the status in the menu then . Do you really have a public IPv4 adress or are you behind a Carrier-grade NA…1
