rossano 
Freshman Member
評論
-
In the log the AP is changing channel from 116 to 36. But I had the fixed channel on 48. Now I switched on fixed 36. I will check if this happens again. Maybe is because the 160 MHz is so wide that goes in a DFS channel?
-
Thank you, let me know if you need anything else.
-
Just happened. The Access point is doing DFS even when it's locked on the channel 48. I am sending you the diagnostic.
-
Thank you, when the problem will show I will inform you. The strange thing is that since I opened the discussion the problem is not showing up.
-
I will, but how to delete the personal information from the diagnostic?
-
I can't use the terminal, in the local interface is not available. But when I open the web interface I can see the current channel information. I will check when the channel is 80 MHz instead of 160 MHz.
-
This is now without reboot. The channel width is now 80MHz. Rebooting fixes the channel width, but after some time the channel width is back to 80MHz.
-
I just enabled the Support Access. The setting of 160 MHz remain the same. But the real radio signal is 80 MHz. I think that the settings change even when the auto DCS scans for the best channel.
