ChrisGer  Ally Member

Hi @CHS sorry for the delay, but we still have school vacations and my summer vacation until 15.09. as I am at the site again (after my vacation) i will test everything again and in the worst case move the notebooks in a separate vLAN and set this (notebook vLAN) with L2 isolation. thx and regards Chris

@CHS PC an WLAN Printer are in different segments -> PC to WLAN printer is working well. The affected device is in the same IP segment as the WLAN printers. Whitelist is enabled and i put the IPs of WLAN Printer and the affected WIndows10 device and put them in the Whitelist -> nothing changed -> printer is not rechable.…

Update @Zyxel_Jeff after i already had such problems with the update from 4.60.0 to 4.60.1, i have looked again at the case be zyxel EMEA. I wrote them the solution to fix my issue ;) Also in the update from 4.60.0 to 4.60.1 it was a "do it your self", which then lifted my USG60 to the new version. Solution (please do not…

Hi @Zyxel_Jeff I've tried to update USG60W from V4.60(AAKZ.1) to 4.62.(AAKZ0) and it looks like since 4.60 there is a Zyxel recurring issue during Fiormware update existing. :s Backup startup-config before starting the firmware upgrade and get a know error message as below: Converting stage1 for startup-config.conf is…

@Zyxel_Emily i found this question and i require also LDAP authentication on USG Firewalls but i found no document that show - configure user authentication on the USG to get access to dedicated destinations - configure admin access to the USG (like the local admin account on the USG). Is there any document existing, how…

update to 4.60 run well and no side effect messages trough console where shown =) thank for implementing the feature =)

@Jeremylin you're like me (luckily I'm not the only one using Zabbix to monitor the on-prem infrastructure) ;) my first invest was to locate MIB values and convert them to a device modell in zabbix. but this projekt is on hold (depending by the actualy sutuation arround the globe). regards ChrisGer

will upgrade today and check the auto config backup via mail" =) if the upgrade and function is successful, i leave a post in this thread.

Hi @PeterUK in my case the USG is routing but do no S/DNAT on WAN1 interface. and i remember if there is a connect from WAN1 back to LAN1 the USG admin interface is listening and responding with the authentication window :/ Regards Christian

@Off i can report, the uplod to USG without reboot after upload is running, but @Zyxel_Emily it's different to other vendors, cause the other refresh the upload progress bar and tell you "upload successfull to solt x". At ZyXEL the progress bar is running until you reconnect to USG to check the upload is still placed in…

Hi @Zyxel_Emily now you flashed me ::open_mouth: the NWA3560-N is running in mesh mode on a USG60W several years very well ;) Device Information the following AP Firmware list is shown in v 4.38 and i'm not sure if they are also supported in 4.39. Regards Christian

Hi @Zyxel_Emily the compatibility list .... there is no more the NWA3560-N and 5560-N in support by USG60W-WLC ? if this is correct, i've to stay on 4.38 (this is working with the APs well) until the zymesh infrastructure is changed to another WLC and mesh-APs :s Regards Christian

Hi @Zyxel_Lukas ,Port WAN1 macht den DNAT und bekommt vom VMG1312 (modem Mode) die public IP durchgereicht. Die initiale, virtuelle IP des Modems habe belassen (RFC1918). Port1 ist die Verbindung zur Firewall. Egal wie man es versucht, man kann das Gerät nicht aus einem anderen vLAN erreichen und muss aktuell ein Notebook…

Hallo @Zyxel_Lukas ,jetzt verwirrst Du mich als leser des Beitrags :/ Ich habe ein VMG1312-B30A und Zyxel hat mir bei einer Anfrage geantwortet, das im Modem Betrieb (nicht Router) aus anderen Netzwerksegmenten (LAN Segmente) die GUI nicht genutzt werden kann, da das WMG nicht routen kann mit den LAN IPs :s Also muss ich…

Hi Hi @@Zyxel_Emily as described, my USG is placed between Offlice LAN/WLAN and central server services "server vLAN". Zyxel - Topic 1 is on ISP Firewall by AviraAV and an different engine/pattern source on the user devices (Win/Mac). Zyxel - Topic 2 2FA/MFA is also provided by Token-app for iPhone/Android devices (soft…