Firmware update appears to be stuck

Off
Off Posts: 1  Freshman Member
edited April 2021 in Security
I apologise if this is the wrong forum but looking for help. I purchased the USG60 today with firmware 4.33 on it. I am no trading to upgrade to 4.39 firmware however it has been going for over an hour. Is this normal? How long should this take or any advice?  Thanks in advance.

All Replies

  • Zyxel_Emily
    Zyxel_Emily Posts: 1,396  Zyxel Employee
    Zyxel Certified Network Administrator - Security Zyxel Certified Sales Associate 100 Answers 1000 Comments

    Hi @Off,

    The complete firmware update may take up to 5 minutes with default configuration file.

    If the device didn't upgrade to 4.39 successfully, reboot USG60 manually and check what version is in the Running partition.

    If the running partition is still 4.33, try to upload firmware 4.39 to the Standby partition.


    See how you've made an impact in Zyxel Community this year!
    https://bit.ly/Your2024Moments_Community

  • ChrisGer
    ChrisGer Posts: 205  Ally Member
    Zyxel Certified Network Administrator - WLAN Zyxel Certified Network Administrator - Security Zyxel Certified Network Administrator - Nebula Zyxel Certified Sales Associate
    i can report, the uplod to USG without reboot after upload is running, but @Zyxel_Emily it's different to other vendors, cause the other refresh the upload progress bar and tell you "upload successfull to solt x". At ZyXEL the progress bar is running until you reconnect to USG to check the upload is still placed in the slot on USG  ;)

    before you upgrade, please connect also to COM Port at the USG and configure Putty for Serial connection to see the upgrade process in the Serail screen =) that can help you to locate an issue or the rollback message in the serial window.
    In my case it takes 10-12 minutes for an firmware upgrade, cause i've arround 189 rules and a lot of address/service elements configured B)

    regards and good luck
    Christian


Security Highlight