Ben434  Freshman Member

Thanks @Zyxel_Jerry - nevermind, I had to switch to another (Free BSD) router meanwhile. Thanks for your assistance nevertheless! 

Hi @Zyxel_Jerry, thanks for getting back - here's me answers: >Can you provide the MAC address on laptops and security cams? Sent in PM. >Can you draw related location of these device? Where are these device, >is it far or near USG60W? All devices are within 15m of the USG60W. >Can you describe how to test the devices…

sent, thanks @Zyxel_Jerry

Hi @Zyxel_Jerry, internal AP - WiFi is provided by the USG60W. Firmware version: V4.35(AAKZ.3) Thanks! B

PM sent - thx.

Thanks @Ian31 - done and dusted. cheerio

Hi again, turns out my last post contained the key to resolution. I deleted the new SSID I had created and renamed the default one and updated it to use the Security Profile I created and use lan1 as the outbound device. Issue resolved, wireless and cable-connected devices on the same subnet, no need to create a bridge…

Hi @PeterUK and @Zyxel_Jerry, thanks for your replies - I was travelling and wasn't able to look into this again until now. I have exported my old config and conducted a reset, after that I tried to manually set up the WiFi: The security profile I have created manually too. Due to the Forwarding mode 'Local bridge' and the…

Thanks Peter, is there a way for me to tell or should I resort to resetting the device and do the WiFi conf from scratch without Easy-Mode? Cheers, B