Comments
-
Hello, any updates on this? Regards
-
Hi Lucious, Sure I will send details. In our case this behaviour was no big issue but it could be for others. and 3. This behaviour should be the case on any switch and vendor. The main issue that made us switch to brand C. in this cas is that they support multi host with MAC-Auth. Due to the fact that the AP is POE…
-
Hi, 1. This issue causes that I have to create additional NPS rules for the Zyxel switches because they don't send port type "Ethernet" and NAS IP. In some usecases the NAS-IP would be important as you can see here: Client IP is actually the RADIUS-Client IP (which could be a NAT or WAN IP) The WIFI/LAN clients, in this…
-
Hi, if I activate MAC-Auth as the only Port-Auth (802.1x disabled) I get: If I activate 802.1x only I get:
-
1. We know how to configure it. I just want to report the described BUG. Radius attributes are fine with 802.1x port auth but are wrong with MAC-port-auth. In MAC-port-auth the actual NAS-IP is written into the Client-IP Radius attribute which the switch sends to the radius server. Also other attributes are missing e.g.…
-
We want to secure all ports of the zyxel to use 802.1x port authentication so the attached PCs have to log in. On some ports we have to setup mac-auth because of missing 802.1x support of the client devices (e.g. an AP). To secure the uplink of the switch we want to use 802.1x also - so the switch should use 802.1x on its…
-
Hey Zyxels, the setup is "pretty simple". Two redundant firewalls each with 2x 10GE LACP into two XGS3700-48 which are stacked so the LACPs are splitted to prevent SPOF. From the two stacked XGS3700-48 about 22 GS1920-48 are connected via 2x 1GbE LACP, and we want to add several servers and switches also via LACP. At the…
-
We noticed that it is still 24 after stacking. (Is there a table where customers/reserllers can find those numbers? ) Is it possible to change that while stacked by creating a new firmware?
