Hun 
Freshman Member
Comments
-
Hello, can you please where can I get this firmware? I have GS1500-24PV1.00(BPW.2), is this the same, could I use the one you're usinG Thanks for your time.
-
Luckily the modem does not go down often (its optical service) just sometimes a tripped breaker cause a pwr failure and about half of the time all connected devices failing to go online, until the switch is rebooted. Buy I guess just have to do this if there is an issue. Thank you Chris for your time.
-
Hello Chris, the switch from the ISP's has a reserved IP but now I've set static in Zyxel GUI as well. So when it comes to connectivity loss, the modem reboots. At some point the mode gives out 169.xxxxxxx IP and it takes a while for switch to get the correct IP from the modem and until then no PC connectivity. So how…
-
Yes!!! It's up and running.....Thank you for your help and your time!!!
-
Yes!!! It's up and running.....Thank you for your help and your time!!!
-
Great info! Since the original injector supplies 24V and the switch port is capable of 48V, how is guaranteed that the AP wont get fried?
-
Montana, sorry I'm not sure if I follow you on this.....what info should I provide you with....? The data sheet says this: Power Method 802.3af/A PoE 24V Passive PoE (Pairs 4, 5+; 7, 8 Return)
-
Hello, Unifi AP AC Lite model is : UAP-AC-LITE Input 24V 0.5A GigE PoE 802.3af Poe So this means, it can't be powered up from my Zyxel?
-
-
Hello, Unifi AP AC Lite model is : UAP-AC-LITE Input 24V 0.5A GigE PoE 802.3af Poe So this means, it can't be powered up from my Zyxel?
-
Hello, thanx for replying ..... I need to get up in the ceiling to find out what model I have..... Unfortunately I'm unable to get this info from the UNIFI controller..... Man, I wish I could power it it up from this switch..... Thank you for now for your time!
-
OK, I guess that means different firmware or something like that...I guess... :-) Thanx again!!!
-
Hello and thanx for your time..... sorry for replying after long time, but I had some personal problems. So, why's is this one phone powering up....could be something physically rewired inside this unit?
-
Hello, just found your answer..... The network slow down, was actually full disconnection when using a crossover to Cisco 7960. What I found out, that on one end, I had to switch the brown and blue pair in RJ45. That maybe caused a short. The rest of the story is in my 2nd post in this community. I hope you'll be able to…
