JNet

Problem solved! As a workaround I set the Firewall→Session Control option "Default Session per Host" to "200". Now it works and the CPU always stays below 50%! The support, especially Zyxel_Kay, helped me very well to analyze the problem. Apparently a few stations are being attacked and are causing a lot of sessions,…

Hi Kay, my overall network architecture is: Zxyel Router (Gateway) →NXC2500 → 5 Access Points The Users must Login via Captive Portal. I only use VLAN 0 because VLAN 20 does not work for me. I wanted to set up VLAN 0 as the admin network and VLAN 20 for the users WLAN with captive portal but that didn't work. So I ran…

Hi Kay, good News - collecting diagnostic Data from Controller works now! I didn't do anything differently than before so I don't know why it works now. I send you the compressed Data via PM and hope you can help me. However, it still doesn't work to collect diagnostic Data from the five Access Points. I tried it several…

Hi Kay, thank you for the tutorial but that's exactly what I did. I wait until the Status changed from “Busy on Controller/AP" to “Standby” but there are no files to download on the "Files"-Site. I restarted the NXC2500 and tried it again - but same Problem. Memory and Flash an the Controller are under 10% so there are…

Hello Kay and thank you for helping me! Is there a way to collect and get the diagnostic files without USB Storage connected? I only have remote access to the NXC2500 Webinterface so i can't attach a USB storage to the Device. If i deactivate the checkbox "Copy the diagnostic file to USB storage (if ready), then there are…