John_t  Freshman Member

Although the speeds are better than before (200mb instead of 80mb), they're still a lot less than what I get on my mobile phone (using the same sim card). I opened a support ticket with Zyxel over a month ago and to date they have done nothing so will be returning it and buying a D-Link DWR-2101 5G router instead which…

I used the Zyxel Air app and repositioned the NR5101 to a different window and now getting better speeds: NR-NSA Information MCC 234 MNC 15 Physical Cell ID N/A RFCN 628032 Band n78 RSRP -55 RSRQ -11 SINR 37

Just seems crazy that I need to use an external antenna when I'm only 30 metres away in clear plain sight from the mast. I have a couple of spare Cisco 4G/3G Omnidirectional Dipole Antennas (4G-LTE-ANTM-D) would that also receive a 5G signal or no? Full…

I tried selecting NR5G at the preferred access technology and the NR5101 went offline (flashing red light): have put back to auto and enabled band auto selection and suddenly much better speeds 250mb (although still not 500mb). This is the signal info now: NR-NSA InformationMCC234MNC15Physical Cell…

My worry with selecting NR5G as the preferred access technology is that it will lose connectivity if for whatever reason it cannot connect to 5G as I suspect it is only connecting to the 4G bands. I'll wait until I'm near the 5101 again before I try this otherwise I think I'm going to have to send it back and purchase a…

I'd be surprised if the Aruba switch that it is connected to is causing a bottleneck but I guess I could try connecting directly to the router the next time I'm nearby to it I could check. The wifi from 5101 was disabled because it would crash after 30+ wifi devices connected to it and I've added a wireless AP to it now…

Firmware VersionV1.00(ABVC.6)C0 Module SW VersionRG502QEAAAR11A03M4G Cellular StatusCellular StatusUpData RoamingEnableOperatorvodafone UKPLMN23415NR-NSA InformationMCC234MNC15Physical Cell IDN/ARFCN628032Bandn78RSRP-68RSRQ-12SINR34Service InformationAccess Technology5G NR-NSA EN-DCBandLTE_BC8RSSI-31Cell ID4208140Physical…

If I set the bands to manual and only select the fastest bands, there is a chance it will lose internet connection (if it's unable to connect to fastest bands) and as I am connected to the router remotely I will have to wait until I am nearby the router to do this just in case. I only have until the end of the January to…

Preferred Access Technology is set to auto. I have tried a factory reset but not recently. I will try a factory reset again as a last resort. V1.00(ABVC.6)C0 firmware is what am I am running currently.

Have tried several firmwares including latest. Bands are set to auto. Antenna is set to internal.