Masterx81

Hi! Sorry for the delay. Ok, i will try to put some devices on vlan 30 on both sides, and i'll let you know. Thanks!

Any news about this? Thanks!

Yes, the clients on the remote site (the ap connected to the GS1900) are unify access points (vlan aware, with vlan30 dedicated to a guest ssid), same model as the local site (where all works), all the devices have the same config on both sites (same controller software, same config). There are also other devices connected…

In my scenario i need to have default port 1 untagged, and VLAN 30 taggen, as my access points broadcast the local lan on default untagged vlan 1, while the ssid for the guests is on VLAN 30 (tagged). As i stated, the 2 vlans on the 1910 works as intended, the only problem is that the gs1900 on remote site not communicate…

Ok, it not work... Same as before the 2 switched seem to not exchange data of the VLAN id 30. The actual config of the GS1910-24 (on local site, all works as it should): And this is the actual config of the GS1900-24HP on the remote site: Thanks for the help!

Hi! The config was the same as yours, but i wasn't forcefully tagging the link between the 2 switches. The link port was configured the same as all the other ports, untagged vlan1 default, tagged vlan30. Now i try to tag both the vlans and i'll let you know, thanks!