Comments
-
Recovery verified. Fortunately it works.Best Regards Paolo Fracas
-
Yesterday at about 14:00 local time I installed the V5.32 beta update package (V5.32(ABUH.0)ITS-22WK41-1125-221101280). After about 15 minutes of inactivity, unable to contact the Firewall, I had to disconnect the power and then reconnect it to see if it restarted.The device restarted with the previous Firmware version…
-
I probably didn't explain myself well.I have a series of backups but since I tried to install the beta firmware the last two (11/17/2022 - 11/23/2022) generate errors and are not loaded.The latest one on 11/23/2022 was definitely working before installing the beta firmware because I used it on 11/23/2022 itself after…
-
Loading the "Beta" Firmware made a mess. Luckily I can recover a configuration saved on 10/27/2022 otherwise I would have had to configure everything from the beginning. It's a nightmare.Two backups from November (the last one from 11/23/2022) are no longer uploaded.The latter had been restored without problems a few days…
-
I wanted to do a test by changing the port of the Backup Program to understand how the USG FLEX behaved but it is not possible to do it on the destination NAS so it would not make sense because Port Forwarding works.
-
Hi Jeff,I remembered that the verification of the deactivation of the "Anti-Malware" option had been done when you connected from Taiwan but I checked it again just to be careful. It does not work.In addition to this, I had already independently tested the exception in July as communicated with my email dated 08/07/2022…
-
I ran the ultimate test tonight by backing up the customer with over 1.5 million files and the USG FLEX 100 with the latest verified configuration as the destination. Backup performed successfully. As further confirmation that the anomaly is not in the Port Forwarding but in the Firewall section.It was the last piece.Best…
-
I ran further tests and used the Log filters to understand if there was any traffic beyond TCP Port 6281 but this is not the case. Either using the filter with the Source only or with the Destination only. This behavior of the USG FLEX Series makes no sense.
-
To keep the community updated... After having performed some tests with the VPN "Site to Site" the problem seems to focus on the internal communication of the USG FLEX. Only by setting the Services to "Any" in the communication rule (Firewall) between External Source and NAS (both with VPN and Port Forwarding) does Hyper…
-
OKThanks
-
I can use WeTransfer but I need an email
-
Zyxel Service is currently setting up a laboratory to perform tests. Today I would have to set up a Site to Site VPN to verify that the problem also occurs with this setup. I keep you updated.Thanks
-
I have the logs created on 04/08/2022 (dd/mm/yyyy) and sent to Zyxel but it is 2.09 GB
-
I have checked the solution and it works. Thank you.
-
There is a way to use a FQDN instead of the Static IP as "Router WAN IP"?