Raymond  Freshman Member

Thanks. Is it possible to add this to the features wishlist?

I updated the Flex 500 with the Weekly update and now is the CPU usage in idle around the 10%. Much better.

@Jeremylin Thanks.

@zyman2008 Thanks, are there some setup recommendations for the Connectivity check?

@Zyxel_Charlie I checked several VPN clients and at all this option is activated, but is still takes 24 hours at max when all the VPN's are up again.

Hi @Zyxel_Cooldia Point 2 is solved. The Internet cable of the active device in the test environment was not connected. Now the Sync status is 'Success'. I have now the following question: The active device at the customer is connected to the Internet via the firewall of the customer. Only the VPN UDP ports 500 and 4500…

I connected to active and the spare ZyWALL 110 via P7 (heartbeat). Synchronize is complete, but sync status is fail. How can I figure out what the problem is?

I have to fill in the following serial number in the primary device: Enter the device's license serial number from the myZyXEL.com server Is this the serial number of the primary device?

I followed the instructions starting on page 224 of the manual in the link: https://www.manualslib.com/manual/1231995/Zyxel-Communications-Zywall-110.html?page=224 The active device was already configured and HA Pro is activated. When I try to enable Device HA on the General tab of Device HA (page 227), then the following…

Hi @Zyxel_Cooldia Can I use the PDF in the following link to setup the HA Pro Auto Sync. functionality? ftp://217.111.207.2/guide/usg/guidenextgen_usg_firmware_4/next_gen_usg_device_ha_pro.pdf

Thanks for this information. Is it correct that we have to buy a licence to use the HA Pro functionality?

Hi @Zyxel_Cooldia I understand, but both devices have to be connected permanently and must have the same configuration. I want to copy the configuration remotely. Because P2 and P3 are not in used, I want to use these ports to connect the primary and the spare ZyWALL with each other, so I can copy the configuration. Is…

I know that HA is better, but the customer don't want to use an extra switch. What is the next best setup for a the spare (backup) ZyWALL 110?