adischer  Freshman Member

Thank's so much PeterUK.....yes you were right. this seems to have been the issue. I was running 5.20 firmware. using the link you provided I was able to recover the system using the backup partition which was still on 5.10. Booting up and also using the password reset trick mentioned in one of the links inside the link…

well, what an evening of focus on wireless configuration all yields ;-) it seems like the WAC6103d-i does not support WPA3. Due to my configuration of it ( I am using a USG110 as wireless control module) the access point must have switched to security mode with little security. I configured now the security profile with…

ok, update from my side. As the answer to Silvia's questions were all "no" and also no further remarks were done I have investigated a bit further myself and have activated in the QoS setting the WMM flag within the SSID settings of my SSID definition. On my USG device on firmware V4.70(AAPH.0) the menu path is…

Hi Silvia, yes, I am using A-MPDU. On 2.4g band I have configured 802.11mode as AX (not b/g). And the security type is configured as wpa3.... so none of the questions you are asking can be answered with "yes". nevertheless, in the station info monitoring, the Tx/Rx rate is displayed at 54mbit max across all stations. I am…

Hi Jeremylin, thank you for your response. Yes, you are right - 1600 Mbps is based on UDP packets. However, for UTM (IDP+AV) Zyxel states "1,460-byte HTTP packets" which I presume is closer to a real usage scenario (at least by a certain acceptable error margin). 533 Mbit would be really more than fine if it was achieved…