af7567 
Freshman Member
Comments
-
@Hummel I have just found that in my last test the results were wrong because I had restarted the router, and this caused the PCs to forget their default IPv6 gateway. After restarting the PCs and testing again with allowing the router to add /32 to the end of the addresses I can see that the incoming connection is working…
-
@Hummel Thanks for testing.I tried the same as you and didn't add /128 so my ACL list shows Src as Any/32 and Dest as the IPv6 address/32 but it's still not working. Do you have your firewall level set to medium, and also using firmware V5.13(ABNY.2)C0?If I set my firewall level to low then the incoming connection works ok.
-
Hi @Hummel I have created a test again for allowing port 25 in to the server IPv6 address to take screenshots. While doing it I also tested with IPv4 and found out that a source address of 0.0.0.0/0 is an invalid IPv4 address too? Anyway here are my IPv6 screenshots. I first created a protocol, then the ACL and left the…
