anno_t34  Freshman Member

You're using an USB serial cable ... in your case COM3. What i suggest is to check, if the COM port is the right one. Perhaps the right port is something like COM30. Regards, A.

(1) Roger that! The error message is gone. (2) I take note of your comment. Regards, A.

Thanks for the hint. Good to know. I ran the test above at the zwyall console. The error message above, at the console, was no logged or at least I did not found any log entry. Further tests revealed that the message is returned for any non defined address object. The "View Log" page has "Note:CONFIG CHANGE" records that…

1. Title "IPSec/L2TP Connection: RemoteClient to Site (zywall Server Role). 2. Enumerate the requirements for implementing the connection. 2.1 : Server Side requirements, includes ISP services. 2.3 : Client Side requirements, includes ISP services. Can you build an IPSec/L2TP VPN Connection from a client device which is…

You're welcome Aleftaugenichts! I don't, but: https://pinoutguide.com/Net/Cisco-Juiper-Zyxel_RJ45_pinout.shtml Good luck and regards! A.

Here are the serial settings for my zywall: Speed: 115200 Data bits: 8 Stop bits: 1 Parity: None Flow control: XON/XOF After loggin in, if you have the credentials execute: configure terminal no ip http secure-server auth-client Don't close serial connection, but check the Web access. If everything is ok, execute "write"…

Thanks for the hint, but restoring the device was not the case. One of the question is "how to run fsck on zywall?", not why or what else. I just wonder, if at booting time, in debug mode, can I initiate the fsck process, for example.

Could you provide a USEFUL documentation, instead of spreading the same misleading documentation, like this one. Just read the first paragraph of this tutorial: "The example instructs how to configure the VPN tunnel between each site. When the VPN tunnel is configured, each site can be accessed securely and allow traffic…

@RAV_ZYXEL: Do you have access to the zywall USG20 right now? I understand that the VPN/SSL remote access is not working, but if the physical location is not to far from you, you could check the zywall on-site. If that's not possible, you should ask someone on location, to assist you. My hints to narrow down the issue,…

@srihiru Your post is to generic. Here are some questions that you should answer: 1. What kind of VPN do you want to implement? Do you want to use the zywall device as a VPN gateway (Remote Access "Server Role") for the inbound traffic from Internet to your local network? Inbound traffic means that the network…