bav  Freshman Member

Thanks for reply! It is clear now! So, just user authentication in AD available without Radius deployed?

Yes! APC is on the ATP500 and all users should get auhtentication via ATP against the AD There are some auth methods available: AD, LDAP,RADIUS. So, I would like to know would it be possible to have AD(users in Security group) direct authorization without any proxies like Radius and so on? I have seen a lot of examples…

As far as I know Home edition can not join Domain. We have Pro and Enterprise and they are in domain. The question is how to set wireless client authentication in AD →Domain Computers group? In this case user should not enter any credentials. If laptop is a member of this Group it should get an access. Othewise get block.…

Thanks! The networks I used here just for example. Actual topology is HQ and 3 Branches. So, I am going to setup hub and spoke, where HQ is a hub and all traffic goes via HQ. Is there any guide about Concentrator(hub-and-spoke) configuration? Currently, I see there that screen from HQ ATP500. There are already 3 tunnels to…

Hi @zyman2008! Thanks for reply! Looks like you explain how to make network connectivity from A to C(via B) and vise versa? It is good to know, but currently I did setup A-B; B-C tunnels via wizard and I do not see any Policy route in the settings of ATP. But it works, ping goes through. How it can be? That is the first…

Just set up two IPSec tunnels via Wizard and can ping .1 IP from the sites. I check the setting created by Wizard and did not find any Policy route or Static routes. How it can be ? The sites have different networks assigned but it routes somehow

Ok! I will try! What is the difference between built-in client and SecurExtender(not for free)? Especially in tunnel-splitting aspect

Could you please clarify your idea? I do not use SSL VPN

Done, but did not help :(

Looks like everything is ok here

sorry, what do you mean?

No! I just have RDP open for virtual server. Port443 is not in use I tried telnet WAN-address port 443 and it replies

Thanks so much! It appears now! Now I am trying to get configuration from server for Zyxel SecurExtender VPN client and get error - Server is not found, check server IP/port. I checked IP and port(443) and they are ok Policy control has rule WAN-to-Device What might be the issue? Auth: Username + password User is allowed

I already had these settings: VPN gateway created and added to int Ge2 2. VPN Connection created (VPN Gateway assingned) 3. Result is the same(no VPN connection available)

Thanks for reply! Could you please explain how to add that rule in VPN connection?