papu  Freshman Member

To specifically answer your questions: no other access points beside NWA50AX/NWA55AX/NWA210AX in my network. Clients through these access point do not show this DHCP warning. Wired clients directly connected to the switch do not show these DHCP warnings. In a previous setup without Cisco SG350 in L3 mode; never had these…

above a screenshot of recurring messages on the Cisco SG350. Next to the two NWA50AX also a NWA210AX is showing the same warning. Beside these Zyxel DHCP clients (the only Zyxel's I have), other clients are dozens of Android/Apple phones/pads, multiple Windows laptops and PC's, as well as a dozen of IOT devices, which do…

I can confirm things are ok now (no complaints from staff after change). And assume you already applied this fix to latest release. If so, can you please unlock the firmware upgrade state of my access points? Or explain to me how to do this through ssh cli myself?

they did seem to solve this problem with a beta firmware. Please refer to

dear Zyxel, the firmware does indeed seem to reinstate 802.11r, at least for Apple mobile clients. Getting lots of expected fast-roaming messages in the event log. Please allow some more time to test this full 802.11kvr roaming also with other clients, and with connection-sensitive scenarios. Thank you very much!

I would be very interested in this firmware. Could you please provide this to me at your soonest? Thank you. I PM'd you my organization and site, Admin support is open.

dear Zyxel, as it seems from another thread the NWA50/55/90 range does not support 802.11r as yet. Therefore it makes no sense for me to continue on this issue. Unless you claim that fast roaming is now supported with this new firmware. If so I am willing to test. Awaiting your advice, Thank you.

dear Zyxel, its almost 2Q2023 and still no update on this matter, May I suggest you modify your marketing material and technical specs that NWA50/55/90 does not support fast roaming. Thank you.

Thank you for your prompt reply. Not the answer I was hoping for; as static routes should work out of the box for any layer 3 switch. May I suggest you update the XS1930 documentation with this mandatory annual license requirement.

An option through nebula interface would be better, but ftp should do the trick. Thank you. 

NWA210AX: NWA50AX:

After switching back to no-vlan, we noticed that this 802.11r issue is only related to the NWA50AX ap's. Apparently this has nothing to do with VLAN (?). With apple clients connected to NWA210AX they do show 802.11r capability, but when connected to NWA50/55AX not anymore. I have enabled Support Access. Thank you.

+1: encountering this ingress filtering issue as well.

For your information: our network consists of multiple NWA-AX devices (50/55/210).

Thank you for your prompt response. We ended up with a cheaper NWA210 as it has the same hardware/antenna specs as a 610d, and is MUCH cheaper than both 610d and 650S. Placing it flat on top of a high wooden cabinet close to the main wall. Seems to do the job for now; measurements seem quite ok. For outdoor we will…