PeterUK 
Guru Member
-
V1.30 stuck booting
So I upgraded to V1.30 all seemed to be working went and changed a setting and the UI locked up so I did the only thing I could and unplug it and plug it back in again 10 minutes later its still boot…1 -
Re: On boot up bridge traffic being allowed without control policy
Their are no rules to allow incoming TCP from ge1 to DMZ on the FLEX200H You should be able to test this your end by a SYN TCP flood to the FLEX200H on reboot traffic is blocked because its getting r…1 -
Re: how to block NMAP lan2lan traffic ?
On the AP you can Enable Intra-BSS Traffic blocking.1 -
Re: Transfer USG1100 config to Flex 500H
I can see why you would want it to be easy as that I had to go from Zywall 110 to FLEX200H doing lots of rule but was not as bad as I thought had to redesign part of the network due to the way I had …1 -
Re: IPSec ESP packets dropped by default security policy rule after reboot
I think I posted something like this under a case where the nailed up end needed WAN to zywall even when Zywall will be outgoing and is allowed it should map the inbound from outbound is that what yo…2
