Alfonso  Master Member

It looks great :)

It looks great ... Thanks Zyxel

Hi @dejmal69 I am going to give to you a theoretical answer. USG110: - Port Forwarding to NAS IP address. (Static destination NAT) - Source NAT. Masquerade the Internet (public) IP Address, using an authorized VPN IP address (usually an internal ip address) - VPN configuration to SBG3500. (be sure the Source NAT address is…

Great info.

I second the idea.

+1 for Mac filtering and port security on Nebula switches.

I gave my feedback ... I am crossing fingers.

Hi @Infotecnika Keep in mind that MAC Address can be easily spoofed. Several ports could need to use the same MAC Address (for example multicast, VRRP, ...) I suggest that your security is not based solely in the MAC Address filters. Enjoy

hi @Antoine_OIS Welcome to the forum There is a lof of information about how to replace livebox at https://lafibre.info/remplacer-livebox/ I hope it helps. Regards

Hallelujah!!!!! I was waiting for it. But i do not see where to do it via Nebula. It will be great to be done via Nebula too (or maybe it can be done and I did not find it)

Hi I suppose the first method is the only effective way to do it. The second one could be allowing the flows with other devices in the same vlan (unless the device would be connected directly to the NSG). Also some specifics attack (as layer two attacks) could be done (DHCP poison, ARP poison ...). So I always recommend…

Hi @ChristianCRS Welcome to the forum. I suggest to review the following videos: https://businessforum.zyxel.com/discussion/4227/watch-videos-on-how-to-setup-nsg-vpn-connections-step-by-step Regards

Hi @damianodec I do not think you can establish a VPN using yje same source and destination ip address range (I am assuming network netmask is /24). If ip address range of the sites are not overlapped, the VPN be configured. Another way to try to connect is to configure static NATs which will be done in (for example) in…

Hi @Paolino1200 Welcome to the forum. I am not expert but i do not think NSG50 could be configured in bridged mode. If you show us your environment, perhaps we could give you another options. Regards

I would like to know too.