Комментарии
-
@calcifer, Thanks for sharing, it helps the community a lot! :3
-
@Alberto77, The cable length will more accurate when it's up to 10 meters.
-
@Chris78, Was there any error message pop-up when stock on the firmware upgrade page, also would it help to click the cancel button?Раздел: GS1200-5/-8 stuck in upgrade mode after upgrade via vpn/different subnet Комментарий от Zyxel_Chris ноября 2022
-
@Alberto77, It's related to the cable quality and the peer device also affected, can you please unplug the peer side cable and test it again, please refer to the "Distance to fault" this time.
-
XGS1250 is for the soho users, the LAG is the static link, as the request LACP, RSTP with 2.5/10 (multi Giga) is the enterprise level then XS1930 series will fit this case.
-
Hello @nitro, There is a misunderstanding since we only have the datecode to support LAG (static link aggregation) for port 9 and port 10 group, it's not LACP.
-
Hello @nitro, It's about the product position, our XGS1250 is the entry-level smart managed switch with the basic features compared to the more premium GS1900 series which is for SMB, hope you can understand. :)
-
@JStirHarg, I assume the connection has failed between the same Vlan or cross Vlan, feel free to correct me if I'm wrong. And may I know if it's possible to access to Zyxel switch or Ubiquiti sw via VLAN4? Please collect tech support file and private message me, thanks.
-
@IanR, Thanks for your update, since we're not sure how Ubiquiti drew the topology (ex, based on which protocol) maybe the known issue caused this, could you please confirm this part with them? On the other hand, you have mentioned the low speed of networking, how did you test it, please share the detailed test step for…Раздел: XGS1210-12 switches with Ubiquiti Access Points and Controller Комментарий от Zyxel_Chris ноября 2022
-
@xyzjots, It's a known issue, in order to support IPv6 on ZON but the side effect is the firmware version which is under ver4.70 will has this symptom, please activate IPv6 on GS2210 and then should upgrade the firmware. Feel free to let me know if have any questions. :)
-
@Fr_mau92, We only guarantee our transceiver with switch however Zyxel currently does not have SFP to RJ45 10G module, but we will release it next year. I will update here if there's any new information
-
@CCVO, Thanks for your update, could you screenshot the console error message also with the running configuration, please private message me, thanks. :)
-
Hello @IanR, Thank you for your purchase of Zyxel Switch. As an entry-level switch for home users, today’s XGS1210-10 only supports LAG on the copper ports, considering home users mostly uses single 10G fiber uplink. As application grows, we also acknowledge the types scenario you described. Zyxel values our customer’s…Раздел: XGS1210-12 switches - No Link Aggregation on SFP Ports Комментарий от Zyxel_Chris ноября 2022
-
@CCVO, Could you please use Zyxel ZON utility to set IP address, if still not works then please screenshot the error message with your configuration file private message to me.
-
@nicnic, Yes, the project owner used to be an ISP that provided the switch to the previous owner (your reseller) and the warranty was defined by ISP. Yes, you need to contact the reseller for further assistance.