mMontana  Guru Member

In the specific case, auto update was setup. However, without allowance to connection due to old geoip DB, i was not able to update manually. Usual chicken/egg problem unfortunate.

AFAIK there's a compare between the one stored and the one available. Only after "acknowledgin" a fresher DB, should the download happen. GEO Ip db is stored into firmware.

AFAIK even the deepest reset will leave some older configuration files into the device, which can be deleted. Any kind of reset should remove logos (file and config), unless someone replaced the original zyxel logo file with a different image.

For Test Scenario 1, +0.02 is margin of error. For Test Scenario 2, -0.08 is 0.4% of improvement, yet still margin of error. Thanks for sharing. @ervee according to your graph, uptime decrease from 48 minutes to 45, more or less 6% of uptime prevision loss. Can you exclude any other change happened on devices connected to…

@Zyxel_Nami you wrote There were no significant differences in power usage between firmware versions V1.00(ABWE.3)C0 and V2.00(ABWE.0)C0. Please, would you kindly share the previous (1.00 ABWE.3) power usage and currente (2.00 ABWE.0) power usage? Between the two firmware releases are the default settings changed in any…

@zyxel_melen I suggest to advertise this intended behavior. Might be a important info into decision process.

AKA if i don't like the performance the current option is ewaste. Thanks.

How old is your power supply? Sometimes USG becomes erratic if the PSU is not providing enough energy.

Some more update. During last two days I did not verified the connection status. Yesterday evening, I used the same HP laptop used since then… Which could not received DHCP from the router. Nice. I edited the adapter configuration, using the same subnet of the network and of the access point. I can ping AP, the "other" AP…

"close proximity" in linear meters of distance how much should be?

7 days later…. WAP 3205v3 is classified by Zyxel as "Wireless Access Point". No category into "Consumer products" fullfill the description, decisely no "SMART HOME PRODUCT". Also, neither PLA Series or Aurora Camera, which by the way is suspended since 2021. Wireless networks. Access Points. Please, get it straight.

To say the least. Should be fine for ZLD 4.x firmwares. But 5.x firmware were released… 2021/04/12 according to release notes available here. https://download.zyxel.com/USG_FLEX_100/firmware/USG%20FLEX%20100_5.37(ABUH.1)C0_2.pdf Page 59. I mean it's a 32 months "whopps" interval. ;-)

I have an interesting yet unexpected update. During last few hours, with the same hardware used for all the tests, i started to have issues. Hardware currently is an HP pavillion laptop, with an RTL8136 fast ethernet adapter. While running windows, operation went smooth every time. Therefore… i booted up a live distro,…

UP. And solution. Ish. What I did wrong: input the wrong port into SSLVPN tab (Configuration → VPN → SSL VPN → Global setting → SSL VPN Port) SecuExtender was not communicating to SSL VPN Daemon on USG Flex 50, missing dialog of the certificate (is stock) should have triggered warning signal to me. After correcting port…

Until now, WAP 3205v3 worked every time I tried since 12 jan, detaching every time the network cable from the test device. The setup was mostly the same with this occurence = D-Link DSL-2740B as source. Before losing connection, no more than 48 hours. but with different set of characters into passphrase (not special…