SELBERG 
Master Member
評論
-
Do as follows: System Monitor / Cellular Wan Status. Set refresh interval to 5 secs. Do speedtests at the same time as you watch table. If you do not use speedtests at the same time, the modem will go into power energy save.
-
Updated to latest firmware from 13/12-24?
-
Do you use router mode or IP Passthrough? If IP Passthrough try router mode, i think that could be your problem.....
-
Just like in picture……
-
-
Tried more than 5 factory reset in GUI but it didn't change anything. Did it directly on my device and it worked significantly better. So a factory reset in the GUI doesn't seem to do the factory reset properly.
-
You have a POE injector between your switch and AC600?
-
You have latest firmware V1.00(ABQY.9)C0 ? https://download.zyxel.com/LTE7490-M904/firmware/LTE7490-M904_V1.00(ABQY.9)C0.zip
-
What is your lan speed? Check system info…….
-
Update firmware to latest...
-
It is possible to modify 4 APN/Sim card.
-
Wifi network? Internal wifi is only to adjust antenna, no internet .... Is there any QR to connect to your Zyxel Air app? B.T.W, my login to web gui in computer is (admin 1234), i suppose you have other login.... Log in to internal wifi in your NR7101 is something else... You need to be close to your unit if you use…
-
Maybe you need to do a diagnostic as in picture. When ready, power off your modem for @least 2 minutes. Restart also computer. Log in with 192.168.2.1
-
Did you push @least 10 seconds on the factory reset button?
