Xydocq  Freshman Member

hello @engineering87 The subnet 192.168.178.0/24 on the WAN port is like the Internet for the USG Flex 50. You will need to set firewall rules to allow incoming traffic from this subnet to the usg flex 50ax.

that's a pitty since Nebula states public IP and not IP on WAN port

hello @Zyxel_Judy Is this going to be supported in the future?

then Site-2-Site VPN would be the way to go. Maybe you're able to establish a VPN-connection on WAN2 of the USG Flex 200 to the Zywall 110.

hello @Rcluce the GS1200-8HP v2 is a managed switch that can handle VLANs. More info can be found here: GS1200-8HP v2_V2.00_Ed4.pdf

hi @jkocovski your setup looks like this: Internet > Zywall 110 > USG Flex 200 USG Flex 200 will block all incoming traffic on WAN port, it will also not respond to a ping. Might be best to replace the Zywall 110 with the USG Flex 200 and use a layer 3 switch instead of another firewall.

hello @Zyxel_Judy I use No-IP.com for DDNS. It uses a custom URL, I registered for my business. I didn't take any configuration steps, the error appeared on day one when I started using the USG Flex. The configuration looks like this: With this settings USG Flex picks the IP of WAN1 but not the public IP. The setup looks…

hello @PeterUK Thank you. Yes I am using Nebula. The Custom setting doesn't work on Nebula. The only thing I get there is: You know what baffles me the most: this nebula-xxxxxxxxxxx.d2ns-nbl.com DDNS thingie, gets updated just fine. But USG Flex refuses to update mydomain.net with the correct IP-Address.

hi @Pinknots What settings did you use on the Asus Router to connect to the Internet? You might have to copy the settings from there to your USG. I am using a cable-connection, and all I had to do, was to set my USG to get public IP on DHCP-mode on wan-port. I was using an Asus ZenWifi AX before.

Hi @Monald Your Zywall USG200 has 1Gbit/s ports on the WAN side. SPI Firewall Throughput is 250Mbit/s and UTM Throughput is 40Mbit/s. In order to make use of the full speed you would need at least a new USG Flex 100 or a USG Flex 200. I use a USG Flex 200 on a 2.5Gbit/s connection and I get a max download of 850 t0…

hi @Zyxel_Judy I disabled the support access and I am not going to enable it again in this case. I am not sure what information could be helpful to solve the problem now, as I deleted the DNS entry on the USG Flex. I tried a different privat DNS and it showed the same result. The situation as it is, is unpleasant, but it's…

hi @gacquier according to this Distinguishing between Smart Mesh and Wireless Bridge: Features and supported models — Zyxel Community both AP's have to support wireless bridge. I only have NWA130BE's installed.

Did you check Site-wide > Configure > Access points > AP & port settings Under Port settings LAN1 has to be enabled too.

hello @Zyxel_Judy now access to the website from the internet is broken. I reversed the settings on the firewall. It is key that the website is accessible from the internet. Local access isn't the main priority. I'll leave the settings on Edge as it is. For the windows machines, I'll edit the hosts file on each of them.…

thank you, I'll try that later today I did try the IP Exception, runs perfectly now. thanks again @Zyxel_Melen