Dudley_Winchester
Freshman Member
About
- Username
- Dudley_Winchester
- Joined
- Visits
- 36
- Last Active
- Roles
- Member
- Points
- 71
- Posts
- 17
- Badges
- 4
Reactions
Comments
-
Thanks Stanley,
I think it is a question of interpretation - and the way you describe is not the same as the user guide!
Option 1:
Ticking the Enable IP/MAC Binding means that devices listed in the static DHCP Bindings list will get t… -
Hi Dan,
Thanks for taking the trouble to reply.
I'm convinced it is a bug, only seen is on the USG3xx series (not 60's 100's) and I have found an answer.
If you uncheck MAC/IP Binding, it still binds MAC addresses to their correspondi… -
Hi Derek,
That almost works! However, the manual shows that the port isolation blocks all VANs, whereas private VLANs can be set in a VLAN-specific way. We wold only want to isolate data traffic (VLAN100) not management traffic (VLAN1) - so…
-
Hi Sakura_T
Thanks for the reply.
You are right; the client PC (Windows 10) has the 802.1X (Wired) authentication enabled and I get the popup on my laptop screen.
The USG has users populated and the Wireless authentication works…
-
Here is a thought, which you may have already considered.
Between switches I guess you allow all VLANs between them, and have set them as "Trunk" Ports - so any traffic can flow freely between the switches (as if they were one big switch).
I have a couple of USG60Ws that I still have on FW 4.25 - when put onto 4.30 they just kept crashing and rebooting every 10-30 minutes. ZyXEL supports answer was to send a replacement (older) unit which I sent back - I now just don't trust firmware …Hi Alfonso,
Thanks so much for your reply. I should clarify.
The phones and computers are each connected to switch ports (ie PCs don't piggy back off phones).
What we do see is that the firewall has a LAN1 with no VLAN (although it's …+1 for a wizard on the USG allowing easy setup with Let's encrypt.Hi ZyXEL_Ryan,
Apologies for the slow response; I was gathering info from multiple customer sites.
The GS1920-24 all looks happy and I tested with V4.50 firmware... very happy!
I'm having problems still on the GS1900-8 using FW 2.40. …I get the same problem. When using Static IP and even having DNS1 & 2 as 8.8.8.8, 8.8.4.4 (Google DNS) and I try to use a hostname, Chrome just shows "waiting for xxx.xxx.xxx.xxx" and it will never save a domain NTP address such as uk.pool.ntp.o…

Community News
Howdy, Stranger!