HUBERT_KASPRZAK

EBL can be managed manually, I expect that if I use a list, the addresses on it are not allowed by the device and the behavior is similar to the control principle. I don't see such a setting, and a person who is on the blacklist gets a rejection instead of a refusal. Which causes frequent attempts to further establish a…

in EBL USG FLEX - whether it works properly Comment by HUBERT_KASPRZAK October 15

Check the log on the USB to see if you have over 50,000 entries , , , warn , user , two-factor auth. , , , , Two-factor Auth. daemon: uam_read_event error, ret = -1

in Delay after reboot for some routing rules to enable Comment by HUBERT_KASPRZAK October 8

Pop3, port standard 110. Please provide the e-mail address to which the virus messages should be sent

in FLEX 200H - detects infected files but passes them on Comment by HUBERT_KASPRZAK October 8

After observing the device for 1 month with the FLEX 200 H - V1.21(ABWV.0)ITS-24WK35-m5760 software, I found that it did not detect 40 email infected with extensions*. bat, exe, pdf, rar, img, doc. Fortunately, Eset removed the threat after downloading the message. Attached is the 200H setting and a screenshot from…

in FLEX 200H - detects infected files but passes them on Comment by HUBERT_KASPRZAK October 1

For 1 month, Flex did not detect 40 infected files in mail, it only detected 2

in FLEX 200H - detects infected files but passes them on Comment by HUBERT_KASPRZAK September 25

HUBERT_KASPRZAK Freshman Member

Comments